INSTALLING OR CHANGING TIMER
1. Position indicator near center of dial.
2. Insert timer connector in proper take-off gear. Position
timer, and jiggle to seat. Rotate onto studs.
3. CHANGING TIMER WITH MAINSPRING WOUND:
See Fig 8. Hold indicator firmly with fingers while rotating
timer off studs. Either replace timer immediately or let
indicator down gently to rest position.
CAUTION. Do not operate reset lever with timer removed
and mainspring wound. If timer is not replaced immediately,
let indicator down to rest position. Move indicator
back to mid-dial position before replacing timer.
4. TIMER MOUNTING: If timer does not seat snug, use
wind crank over studs, bending each one slightly toward
center. If plastic cover is loose, rub screwdriver blade along
edges of stainless steel cup, to roll in.
