Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Mobil round pumps face glass gasket?

Greetings, Does anyone know where to get the rubber gaskets for the face glass on the round Mobil pumps from the 60's - 70's. Any help would be appreciated, thank you!

Yes, i can help, once back at my desk on Monday.

Cheers
Chris

Thank you Chris, looking forward to hearing from you.

Pleasure, restorer has renovated pump (and thus rubber) stored OFF site; when next he is there, he will send me a profile pic, he mentions that there are TWO profiles that work, back with you in a few days…

Thank you again.

Have P.M.'d you, but cannot seemingly attach pics to PM's?

So here are the TWO profiles that can be used with Gilbarco T1:

Message to me, from restorer of Gilbarco T1 Mobil 'round' pump:

Hi Chris,
I checked, the lenses you had made fit behind the upper door of the T1.
That means it will use the "S" rubber- see diagram below...

I'm 99% sure that some of the pumps I stripped before used an "H" rubber.- see also below...

This means the rubber type depends on the size of the lens- whether it sits inside the frame, using the "H" rubber with a locking strip or
whether it sits behind the frame using the "S" profile.
The main issue is that the one side of the rubber will receive the Sheetmetal (1mm-1.5mm) and the other the lens (3mm-4mm)

These should work satisfactorily:

Thank you again sir. Trying to figure it out myself, I came up with the "S" profile also. Appreciate it!