Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Lubester Restoration

Hi Everyone,

I'm a newbie here and getting ready to tackle my first project. I grew up on a farm and have collected a few old farm pumps and lubesters over the years. I thought starting with a lubester restoration would be the easiest.

I have removed the pump assembly but still need to remove the tank lid. Is there a way to remove the hinge pin without damaging it? I have attached a few pics.

Also, what is the preferred method for removing old paint - abrasive blasting or chemical dip/strip?

Thanks,

Clint

I would use a small grinding disk and grind the end until washer falls off. The end has just been peened over washer. Sandblasting is a good option being careful around rusted through spots. Good luck on project, update us with pictures as you go along.

Thanks for the help!

Clint

Yep, that's what I do to. I use an angle grinder to remove the peened end and then eventually replace it with a long bolt.