|
#750219
Thu Jun 11 2020 06:08 PM
|
Joined: Dec 2014
Posts: 297 Likes: 7
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Dec 2014
Posts: 297 Likes: 7 |
Started to work on Erie pump and trying to open doors. The screws are very bad, spraying with wd40 and tried heat on one. The heads of screws not the greatest. Can someone tell me or post a picture of a door open. My question is, is there just screws that come right out or is there a hook and latch system in place? Also if my last resort is to drill is the panel indented where the screw sits?
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Jul 2002
Posts: 3,739 Likes: 87
Veteran Member
|
Veteran Member
Joined: Jul 2002
Posts: 3,739 Likes: 87 |
Those large heads take the biggest screwdriver you have.
Or you can use a ground down edge on a fender washer held with a pair of lock jaw pliers.
They are attached to arms that swivel around and latch to the body.
They only move one way to unlatch - and in reverse to latch.
They can be horrible to get loose.
Try clamping a long wood working clamp across the side of the body next to a head.
This can relieve some of the pressure and allow you to turn the unit.
If you think these are tough - wait until you try and remove the sight glass retaining rings . . .
Later . . .
Jim
P. S. - feel free to call if you need more help.
|
|
|
|
Joined: Nov 2008
Posts: 138 Likes: 11
Petro Enthusiast
|
Petro Enthusiast
Joined: Nov 2008
Posts: 138 Likes: 11 |
Does your door look like this?
|
|
|
|
Joined: Dec 2014
Posts: 297 Likes: 7
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Dec 2014
Posts: 297 Likes: 7 |
Jeff those aren't the doors they are for erie 748.
|
|
|
|
Joined: Dec 2014
Posts: 297 Likes: 7
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Dec 2014
Posts: 297 Likes: 7 |
Hey Jim, if it is a latching system would you know if clockwise or counter clockwise to unlatch? The screw I applied heat to would only turn very little hence the latching? Along with minimal movement it seemed to stop that's what made me believe the screw didn't just unscrew from the door. So does the latch or hook stay attached to door? if this is the case?
Thanks Joe.
Might give you a call tomorrow.
Joe
|
|
|
|
Joined: Nov 2008
Posts: 138 Likes: 11
Petro Enthusiast
|
Petro Enthusiast
Joined: Nov 2008
Posts: 138 Likes: 11 |
|
|
|
|
Joined: Jul 2002
Posts: 3,739 Likes: 87
Veteran Member
|
Veteran Member
Joined: Jul 2002
Posts: 3,739 Likes: 87 |
Sorry, the latches will go either direction.
Here are photos of one of my disassembled 71's showing the swing arm inside the door edge and the corresponding latch area in the side panel.
|
|
|
|
|
|