Due to the help of a long time friend and fellow Oldgas member (Thanks again Craig!), I was able to recently find the top head casting for my Wayne 50 project.
I am still in need of the following parts if anyone would happen to have any of these ORIGINAL parts:
2 Vertical corner rails for head support
2 stair stepped sheet metal panels for side of head
1 rounded sheet metal panel for upper side of head (side opposite of nozzle)
1 nozzle receiver casting
1 nozzle support casting (fork)
2 computer bezels (hold clear glass over computer)
1 computer
4 showcase door frames (2 large/2 small)
1 Center pipe that runs through showcase
4 showcase sheet metal corners/shelf brackets
2 shelf support brackets
1 upper showcase interior sheet metal trim
Any leads or help is appreciated. I'm not really a pump guy as evidenced by my descriptions above - but I'd like to continue gathering pieces to complete this someday.
Thanks!
