Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Pump ID pleaset has this pump

I ran into a fellow in Colorado that has this pump. I do not have Jack's book with me and thought I'd post some pics. I am thinking Clear Vision or Hayes but not sure. As you can see the original skins are somewhat fluted. He put repo gallon numbers on it along with plastic cylinder. There should also be a couple of lights hanging out from under the bonnet which he has but didn't put them on. He is also wondering what piece is missing that goes around opening for the cast iron handle and tags above cast iron door.
Thank you for the help,
Rod van Pelt

Clearvision ---I have 1 just like it ..Tom

Clear Vision 263

Larry

Skins are not rolled or stamped, made w/ a Brake, hence the flats.

Check the Book Store here or w/ Jack about getting a Pump Book.

I have the book just didn't have it with me. Didn't want to give him wrong info. He has no desire to stat collecting pumps, just wants info and a few parts.

Thanks Tom and Larry, Any one have a pic of the piece, probably cast that goes around handle?
Rod

The trim piece that goes around the handle is a circular 1 inch piece that fits there..

Tom,
is that piece around base of handle flanged and held on with 4 screws onto the skins? Could you please post a pic here or email the pic to vanpeltrk@yahoo.com ?
Thank you,
Rod

It's like a large Cast Iron Flat Washer that conforms to sheet metal.

PICTURE SENT ... TOM

Thanks, Tom for sending the pic of part needed. Anyone have this piece? It is probably cast iron and made to fit the curve in the skin.

Thank you for your help.
Rod van Pelt

Until he finds an original, cut from 1/4" steel plate

Yep, that's what he might have to do.

Rod... if you want me to make a template for you I will... Imam on vacation ow and will be back the 15th..Tom

Should be able to do a good guess w/ 4 mounting holes + 1/2" for diameter. Inside hole large enough for packing gland nut.