Thanks buzzy.

And I think I need to correct myself. I think it was one steel rod that came out of the top in the center. The threaded steel rod went through an upside down u-channel. You placed two advertising signs in an upside down V pattern between the u channel (at the top) and the little embossed bumps on the top lid. Then you tighten the threaded rod to hold the signs in place.

-Steve

Last edited by Speedracer; Wed Jan 11 2023 02:57 PM.

-Steve B. (WTB: 48" Flying A button, 48" black/org Phillips 66, White Star, and Chevrolet Signs. Also looking for a Wayne 866. Send a PM. Thanks.)