|
#762237
Sat Mar 27 2021 10:29 AM
|
Joined: Feb 2020
Posts: 6
Member
|
OP
Member
Joined: Feb 2020
Posts: 6 |
Anyone have any pointers on fitting the "contains lead" porcelain signs to a curved surface?
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: May 2018
Posts: 211 Likes: 36
Petro Enthusiast
|
Petro Enthusiast
Joined: May 2018
Posts: 211 Likes: 36 |
I’ve had some luck curving reproduction porcelain signs. I heat them up to 180f and then place a 2x4 of either side and then slowly apply pressure to the middle.I usually re heat them about three times before you get enough of a curve. I’ve never tried with an original sign so I can’t say if that will hold up.
|
1 member likes this:
KevinD |
|
|
|
Joined: May 2012
Posts: 1,871 Likes: 48
Veteran Member
|
Veteran Member
Joined: May 2012
Posts: 1,871 Likes: 48 |
You can do it with tie down straps, have done it many times. If I get out into the shop tomorrow I’ll take a couple of pics. Don’t like the large reproduction ones they don’t fit that well.
Have gas all the time
|
1 member likes this:
KevinD |
|
|
|
Joined: Feb 2020
Posts: 6
Member
|
OP
Member
Joined: Feb 2020
Posts: 6 |
Thanks guys! It worked! Used the ratchet straps and a little heat (not much) and curved it around an old auger tube. Thanks again for the ideas!!
|
|
|
|
|
|