Very good points Steve and Mark. I personally think Mark is right.

I have heard the same as Mark about these possibly being fantasy pieces (I wasn’t sure if it was true, but Marks explanation above makes a ton of sense).

However, either way, I think marking them would still be the right thing to do - to prevent un-informed or new collectors from making the mistake of overpaying at an auction or somewhere else etc. etc.

Just my 2 cents
-Steve

I totally agree. If vintage it is awesome

...I agree completely...

It is definitely a fantasy piece. I’ve had this one for about 15 years and until this post I had forgot I even had it. I remember years ago there was a post about these bases and Dick Bennet stated they were made in Mexico. If you are going to recast them, I would definitely put a date on them.

...anyone notice the fonts used in the product/service words are mixed up?

...both serif AND sans serif fonts are used...pretty sure Texaco would have had something to say about that...and a reputable foundry 'back in the day' would have had compete cases of fonts, and wouldn't need to do this...

HEATER HOSE

ANTIFREEZE

I have a couple of these under Texaco signs and I remember they have a raised 1939 somewhere on the bottom.I also measured them at one time, diameter, and one was a little smaller than the first one I had. The first one I`ve had at least 15 years. My question is basically: what is the diameter of the one being coppied,original???...thanks Tom

I will answere my own question on diameter....... Coca cola base is 22 even.....Texaco base #1 is 21 even....#2..is 20.75 inches.....I think Texacos are repos....because of the shrinkage in recast.

Waited till all comments were herd, to prevent shinking of an already small base will have to start fresh with a new base corrected with flaws and dated, although dates will always be ground off or filled,will always happen ! new base will be clean and sent to a good caster. more suggestions?

Harder to fill recessed letters. And if they are deep enough people will know where they were ground off.

However, it sounds like this base was a pure fantasy piece anyway.

Here's one a guy tried to sell me years ago for lots of money... And I didn't buy because I was certain it was a fantasy/repop piece. Glad I didn't buy it. Now I'm just mad at myself for not noticing the fonts, like Mark did.. LOL

I'll admit, the paint colors looked cool.

...don't feel bad - I'm a graphic designer...I spend all day looking at fonts...

Mark if you was laying this out tell me why you wouldn't swap places with Batteries and Heater Hose,and drop Heater and add S to hose. Seems it would fit much better.
If your heater hose is new and everything other hose has a hole in it your in trouble.LOL!
I'm not going to beat it up it is what it is,I will beat up that red and white paint job . Looks like it needs to be displayed with a clown car! Too much going on for me, but you know what they say about opinions,

I am interested in one also , what will they cost and how much for shipping thanks

I think you should make`em I already have two but would be interested if they said "working girls" in any font, but script would be nice!.....I can`t wait.......Tom