Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion New Bee - Gilbarco 1006 Questions

Hello all.

I have what I think is a 1006. The tag is hard to read See below if I uploaded it correctly. It looks like is says
L1006B18. I am not sure it is is white paint or oxidation.

[img:center]https://scontent-ord1-1.xx.fbcdn.net/v/t...amp;oe=594C335B[/img]

My questions.
1. How to properly restore tag. Looks like it is engraved.

2. Who sales the rubber gasket material for around the door?

3. How do I measure the hose? ID or OD?

Thanks
Bigg-O

Here is some information:

http://petrolianacollectibles.com/gb%201114.htm

Jack Sim

Welcome, The rubber can be purchased from Gas Pump Heaven or Pergl. Both are online. The hose for this model was always 3/4" by whatever length needed but usually around 10'? I.D. tag can be polished then using a thin black paint cover entire tag. Allow paint to set up until almost dry then using a rag with paint thinner, carefully remove the high spots leaving the black background. Good luck, Paul www.severngaspumps.com