|
|
#47972
Fri Sep 07 2007 05:53 AM
|
Joined: Aug 2006
Posts: 892
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Aug 2006
Posts: 892 |
VEEDER ROOT QUESTION....Before I start doing something I will be sorry for, I want to replace the price per gallon wheels at the bottom of the unit. I see there is a pin that holds the piece in place but there doesn't seem to be enough room to lift it up without hitting the wheels above. Any secrets here? Thanks. Tokheim 39 unit!
Mick
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
#47973
Fri Sep 07 2007 06:20 AM
|
Joined: Nov 2000
Posts: 7,791 Likes: 9
Veteran Member
|
|
Veteran Member
Joined: Nov 2000
Posts: 7,791 Likes: 9 |
Don't know how to put them in, but I did want to mention I have a few sets of NOS pricer wheels. Email me if you are interested.
Jack Sim
Author, Gas Pump Identification book and Air Meter Identification book
Author, 1st & 2nd editions of Gas Pump ID book, 3rd edition is now available at www.gaspumpbible.comAir Meter ID book also available
|
|
|
#47974
Fri Sep 07 2007 11:52 AM
|
Joined: Dec 2006
Posts: 3,369 Likes: 7
Veteran Member
|
|
Veteran Member
Joined: Dec 2006
Posts: 3,369 Likes: 7 |
You will have to take the head off to access the price wheels properly .Make sure the head is reset,
before removing, then do not let the wheels turn on the head when replacing.They all should be at zero when you are done.
The price wheels are all different except the middle ( C ) wheel....there is a B,E,A,F and two C wheels....most variators are marked with the corresponding letter.
Good luck.....( laughing maniacly!!!! )
It's not too hard to do.
Hey Jack....I need some wheels !!!!!!
Joe
Veeder Root Rebuilds.....since 1987
Veeder Root Identification CD
Gas Pump Clock Repair
jkyocom@bellsouth.net
|
|
|
#47975
Fri Sep 07 2007 05:35 PM
|
Joined: Jun 2001
Posts: 238
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Jun 2001
Posts: 238 |
Hey Joe,
Can you reset the head when it's off of the variator? If not, why not? There is just a single drive shaft out of the top right?
Thanks, Jeff
|
|
|
#47976
Fri Sep 07 2007 05:51 PM
|
Joined: Dec 2006
Posts: 3,369 Likes: 7
Veteran Member
|
|
Veteran Member
Joined: Dec 2006
Posts: 3,369 Likes: 7 |
That is a tough one .....yes you can reset it. But there are all kinds of stuff that can happen if the gears with the stops get out of sinc with the wheels.
Veeder Root Rebuilds.....since 1987
Veeder Root Identification CD
Gas Pump Clock Repair
jkyocom@bellsouth.net
|
|
|
|
|
|
|
