Oldgas.com Home

Click here for Petro Porcelain Sign auction listings

Home | Help | Events | Auctions | Parts | Pictures | Links | Contact

Register Log In

Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Proper torque

Print Thread

Proper torque #41929 Sun May 06 2001 06:19 PM
A Anonymous Unregistered
Anonymous Unregistered A	What is the recommended torque value for the 3/8ths in. nuts on the threaded rods, on a Wayne Cut 615 that holds the glass cylinder intact?

Please use For Sale forums to sell

Please - NO offers to Buy or Sell in this forum category

Statements such as, "I'm thinking about selling this." are considered an offer to sell.

Re: Proper torque #41930 Tue May 08 2001 06:15 PM
Joined: Dec 2000 Posts: 1,728 Likes: 19 Hugo, MN, USA Ron Scobie Veteran Member
Ron Scobie Veteran Member Joined: Dec 2000 Posts: 1,728 Likes: 19 Hugo, MN, USA	I only recommend finger tightening... Old glass is very brittle. Any uneven pressure may result in breakage. Make sure you have some type of gasket material above and below the cylinder. Ron Ron Scobie http://www.gaspump.com or rscobie(TheAtSymbol)gaspump.com Phone - Six five one-653-6503

Moderated by Oldgas, Ryan Underthun

Hop To

Link Copied to Clipboard

Click here for Gas Pump auction listings

Copyright © 2023 Primarily Petroliana Interactive, All Rights Reserved

Powered by UBB.threads™ PHP Forum Software 7.7.5