Any interest in some display case lubsters? I cut out an opening in three or four different sized lubsters and was going to make them into display cases. The lubster cabinets have been cleaned, sandblasted and epoxy primed. The pump mechanisms have not been blasted or cleaned yet.
I am planning to keep one for myself, but have decided to sell the remaining ones. I cant remember if I have four or five total.
The hard work has been done on these. I will assemble them and get pictures if there is any interest.
There has been a pretty good amount of interest in the display case lubsters. I have attached a picture, I have two of these and they are pretty much identical. They have been blasted inside and out and put in PPG epoxy primer. I have the pumps and covers for them, but they have not been blasted and primed.
If anybody has done one of these before, they know the amount of work it takes to cut one of these open. They had stiffening braces inside the helped keep the tanks from bulging out when filled with oil. All of that had to be cut and ground out, then all the goo was cleaned out inside, blasted and primed. I would say it took me at least 1.5 hours just to cut the hole out and remove the stiffening braces.
I was going to do these for myself but really dont have the room to put them.