I know a few here have the 373.
I could use some info on the faces.
I could use a template of a 541 and a 373 face.
I mainly need top and bottom marks, and all holes traced.
similar to the drawing. A totalizer face for the 541 would be easier to use for my calculations.
What I need to know is...
IS THE CENTER OF THE HAND HOLE ON THE 373 FACES ON THE SAME HORIZONTAL PLANE AS THE CENTER OF THE COMPUTER AS SHOWN BY THE BLUE LINE....
SAME, HIGHER OR LOWER ????
IF NOT THE SAME, WHAT IS THE DISTANCE, CENTER TO CENTER, OF THE OFFSET....??????
I BELIEVE THE 373 HAND HOLE IS LOWER THAN COMPUTER FACE CENTER.
THAT IS THE TRUE MEASUREMENT I NEEDCan anyone help me on this?If I had these faces I could figure it out for myself.
Thanks
Joe