I am restoring a Bennett 646-B and my Veeder is missing the bell unit. Actually, it doesn't have anything associated with the bell (no hammer, nothing).
The ID plate on the commputer says: "factory rebuilt" and is stamped #535. I could post a pcture to help you identify it.
Would need everyting to install a bell and complete my restoration.
Also, if someone could post a picture of what this bell unit is, I could see what I am missing.
These are two versions of the three side mount bell systems I know of. The third uses a more shallow bell and shorter bell shaft. The cam part is on the bottom center shaft and the pin should be at 4:00 position
Veeder Root Rebuilds.....since 1987 Veeder Root Identification CD Gas Pump Clock Repair jkyocom@bellsouth.net