|
#603978
Tue Mar 17 2015 10:07 PM
|
Joined: Jan 2003
Posts: 1,479
Veteran Member
|
OP
Veteran Member
Joined: Jan 2003
Posts: 1,479 |
Hi guys - long time to show -
I am working on a Hayes Square Visible pump that will be going to a auto museum and I can not find any photos of how the conduit was run and bent originally, can any of you post photos of yours so I can see how it was run please.
Travis E. Towle Topeka, Kansas
785-408-3409
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Jan 2009
Posts: 5,980 Likes: 24
Veteran Member
|
Veteran Member
Joined: Jan 2009
Posts: 5,980 Likes: 24 |
Mine went up the center of the pump inside the aluminum large tube.
Craig
|
|
|
|
Joined: Jul 2001
Posts: 4,006 Likes: 7
Veteran Member
|
Veteran Member
Joined: Jul 2001
Posts: 4,006 Likes: 7 |
Mine did the same as Craig's through the center pipe.
Thanks, Phil _________________________________________________ Looking for any old pumps, or nice 5 gallon cans.
|
|
|
|
Joined: Jan 2003
Posts: 1,479
Veteran Member
|
OP
Veteran Member
Joined: Jan 2003
Posts: 1,479 |
Well darn, that's not how mine is at all. Mine is set up for conduit going outside the cylinder.
I am thinking the closest thing I am going to find for where it comes out from below the cylinder is a 1/2 inch conduit explosion proof body -
|
|
|
|
Joined: Jan 2003
Posts: 1,479
Veteran Member
|
OP
Veteran Member
Joined: Jan 2003
Posts: 1,479 |
Here are more photos as to what exactly I am asking about, one is from Jacks book, the other is the original drawing, and the third is my pump how I was going to do it until seeing it was not correct:
|
|
|
|
Joined: Jan 2003
Posts: 1,479
Veteran Member
|
OP
Veteran Member
Joined: Jan 2003
Posts: 1,479 |
As I look at it now, unless I can get a photo of an original set up here - it looks like I need to take the explosion proof body - grind off the screw in end, plug and weld it, then drill and tap a hole in the top cover - make sense? Thoughts?
Travis
|
|
|
|
Joined: Jan 2009
Posts: 5,980 Likes: 24
Veteran Member
|
Veteran Member
Joined: Jan 2009
Posts: 5,980 Likes: 24 |
Yes, see that now. Had one of those and I think the end of that little box came off. Two small screws. Tough to find one laying around though. Hopefully someone here has a picture of their restored one.
Craig
|
|
|
|
|
|