I know this a long, long shot but has anyone have an 8" computer for a Tokheim 36 that they would sell? Fingers crossed.

Actually the TOK. 36 used a 10 3/4" VR.
The Tok. 34 used an 8".
I don't have any extra 10 3/4" but I have the 8".

Tom.

I believe that I have a top half of a Tokheim 36 around here somewhere.

Thanks guys, I guess I need to do more homework on this. I did do a search here and as of yet have not found the info I need.

If you are needing a computer specifically for the Tok 36, then listen to Tom.
You will need the 10 3/4 VR.
The Tokheim 34 used the 8 inch but the 36 used the 10 3/4 and the Tok 36B used a 12 incher!

Thanks Kevin, I spoke to Tom about this, there is some confusion and will be on him tomorrow.

10-3/4” is right for the 36. I just got extremely lucky last week and found one for mine.

You can use a 12” if you modify your face pans. I have done this.

True, mine has a 12" in it now, just depends on if you want it correct or not?

Thanks guys, I think I'll keep looking for a complete computer and if I give up do the 12" route.

I mentioned above that I have a complete top half of a pump that I will be parting out. It has a computer in it and is in decent shape, I think. I have not looked at it in a bit.

Ryan, school me on this please. I thought I knew what I needed but I'm somewhat confused now. If I get the top half what can I use for the bottom half if I get yours. Also could you please post a pic of it. Thanks.

If you get the computer and you want me to rebuild it, just have Ryan send it to me.
This is one I did for the CD
Thanks
Joe

Thanks Joe, beautiful work for sure. Actually if I'm lucky enough to find a couple of pieces it will be a rust-o. And that is just way too pretty, so at this time I'll pass.

I have the top half of the entire pump, I can remove the computer that you need and just sell you the computer. I was planning on parting out what I have anyway.

Got it. I misunderstood you. PM sent. And thanks.