Anyone have a close up picture of one. AN original one.

i will get one latter today.charley

Here is one out of Jacks book.

not the best pic. charley

Thank you Charley, have Jacks book, but needed to see one in real so that I could tell. It looks like the bottom has to be 8 sided. Thank you.

Attached is a photo of the site glass that came with me National Apex 90. Hard to tell from Jack's book if this is original but I think it is. Hope it helps.

Yes, that is the original visi gauge for the National Apex 10. It is the only site glass that has that type of spinner be very careful with that spinner it is very fragile..

Bruce.

Here two that I have, one stainless top cover and one cast top cover. Bottom cast is different below the glass.

one more picture

WOW, they had two different models. My problem is that I need two. Thank you everyone.

mine is just like the one with the stainless hat, spiner and all. i need one of the hats.thanks charley

Craig,
The factory parts breakdown for the 90 & 902 does NOT show the Visi that Wayne posted belongs on your pump.
Ron

Bruce, please confirm that my visa gauge fits a National; 10 and not the 90 that I have? Thanks

Yes,The visi gauge that you have is for a National Apex 90.
Bruce.

I have a National 90 also but not sure which one I will need. All guts are in the pump though. New and just getting started.

This is the spinner out of my National Apex 90 this is the only pump that I know of that uses this type of spinner.



Bruce.

Bruce is correct. That's the one I included with the copies of the Visi that I made. I made it out of bronze. The "Glass must be full before and after delivery" sign was required in some states.