Hello all,

I am in the throws of doing my 3 rd gas pump. It is a WAYNE model 515. I am missing the drain handle on the top...see my picture of my pump body top. The picture of just the handle is what is available to me...but it doesn’t look right and the last picture shows what I think it should be? Were there several variations of these drain handles? What is the picture that shows just the handle..is it for another pump. I could probably make it work...but not sure...looking for some advice gentlemen. Thanks...Rob

Here's some to choose from. The third one from the left is brass.
Ron

Here's a picture of the setup on my 515, It matches the center picture you posted. I have never seen the lower setup before, although it looks very interesting

The shut off is attached to a rod that goes down the inside of the pump body and comes out with a lever next to the drain back pipe. It shuts the valve when you insert the nozzle and lock it in the drain back tube

Ok...this is very helpful gents! Jerry, yours is identical for sure. Ron, I will sort out which I would like. Thanks again! This forum is super useful

Question Jerry....on your pump...what goes in the following pictures? Also, do you have a picture of the pump handle assembly, mine is broke off and I will need to make one. Would love to see any pictures you have of your pump.

Also any idea what goes on these 2 sets of 2 holes...it looks like a sign?

Thanks

The square hole is where the shut off is tripped when you lock in the nozzle,

The holes about the handle hole are where the data plate and the keep stuffing boxes tight plates were on mine

PM sent